Whether you're new to Phase or already using it, find out all the essential information to set it up seamlessly with djay PRO.
You can use Phase and djay PRO in two ways:
Learn how to set up Phase with djay PRO via HID in less than 2 minutes, or scroll down to access our step-by-step guide.
Follow the steps displayed below to set up Phase with djay PRO via HID.
Plug in your Phase Receiver and any mixer/controller you have.
Open djay PRO.
In djay PRO screen, set the deck control to “WIR” (the dedicated control mode for Phase).
Place the Remotes on top of the records, and wait a few seconds for calibration before spinning (Make sure your magnetic stickers are well in place before).
You're all set!
If you have any questions about Phase or how it works with djay PRO in HID, read the FAQ below, or directly reach out to our product specialists!
Learn how to set up Phase with djay Pro in less than 2 minutes, or scroll down to access our step-by-step guides.
Connect your DVS mixer to your mobile device. Depending on which device you’re using, you might need one of the following adapters:
- iPad or Mac with USB-C port: USB-C to USB Adapter
- iPad or iPhone with Lightning port: Lightning to USB 3 Camera Adapter
Set the deck mode to “USB” to enable DVS mode.
Connect your Phase to a power supply (5V) using a USB cable.
Connect the Phase Receiver to the "Line" inputs of your mixer (or DVS soundcard) via RCA.
In the Phase Manager Setup tab, set the Phase DVS signal to “Custom” at 1000hz.
Open the djay app, enable DVS in the settings, and set the decks mode to "Relative".
Now, place your Remotes on top of your records, and wait a few seconds for the calibration to complete before you start spinning.
You're all set!
If you have any questions about Phase or how it works with djay PRO in DVS (RCA), read the FAQ below, or directly reach out to our product specialists!
